Front Derailleur Basics - Page 1 of 2


Figure 1

Figure 1 - A standard front derailleur

The front derailleur on a bicycle has the task of "derailing" the top side of the chain entering the front chain ring so that it can be move from one chain ring to the other. The front derailleur also has the task of keeping the chain on the chain ring that it is currently wrapped around, essentially working as a chain guide so that the chain does not derail unintentionally while travelling over harsh terrain.

The front derailleur will only operate properly when the chain rings are engaged in the clockwise rotation since it is the top side of the chain (drive side) that must be forced onto the larger or smaller chain ring in order to change the gear ratio. Also, the chain used for a multi-speed bicycle is thinner pitch than the type used on a single speed cycle, and it is also more flexible from side-to-side, allowing it to be forced over to the next chain ring. Adjustment and setup of a front derailleur is a simple task once you understand the basic operating principals.

The typical front derailleur shown in Figure 1 represents the most commonly available steel plate style that most modern cycles are equipped with. The front derailleur sits just over the largest front chain ring, held in place by the clamp that is secure around the seat tube. When the shifting lever is moved, the chain cage is pushed or pulled, forcing the chain to jump off the current chain ring and onto the next one.

Newer shifting hardware is "indexed", meaning that the shifting hardware is matched to the derailleur so that one "click" translates into one shift. Older shifters are simple levers that allow you to move the derailleur position in either direction until you have shifted gears. The older systems are much easier to setup and maintain, but do make an annoying ratcheting sound as you move between gears.

Figure 2

Figure 2 - The rear derailleur takes up chain slack

Figure 3

Figure 3 - The cage derails the chain

Figure 3 shows the movement that the front derailleur makes as it changes gears. The steel cage pushes against the side of the chain, causing it to jump over to the next chain ring where it is picked up by the sprocket teeth and wrapped around that chain ring in the clockwise (pedaling) direction. Back pedaling while you shift will jam up the chain since the front derailleur cannot force the chain off of the chain ring in the counter clockwise rotation.

Figure 4

Figure 4 - The high and low limiting screws

High and low limiting screws (shown in Figure 4) must be properly adjusted to allow the full range of motion without having the chain become shifted right off of the last chain ring.

Adjustment of the min and max setting is accomplished by turning the adjuster screw with a Phillips screwdriver as shown in Figure 4 until the shifting range of motion is set properly. Having the cycle up on a stand so that you can turn the cranks while making the adjustment is the best way to set the min and max screws properly.

Viewing Page 1 of 2



You can build it yourself from our easy to follow DIY plans!