- Joined
- Feb 20, 2013
- Messages
- 869
- Location
- Axedale, Victoria, Australia
- Website
- axerail.coffeecup.com
I have just posted details of what I am using on my eLecTricks thread. You may be able to modify it. The front mount is pictured, the rear isn't, yet, as it hasn't been finalised. What the top seat connection point will consist of is two telescoping tubes: Outer pieces will be hinged from the seat, spaced equally each side of centre. The inner, or bottom telescoping parts will be attached to a bracket lower than the height of seat attachment - either side of your top of seat support, if you like. Their lower ends will be attached at a pivot point. The telescoping tubes will be fixed in position with two pins, allowing multi-positions for seat rake angle adjustment.
Remove the pins, and the seat just lifts right out.
Remove the pins, and the seat just lifts right out.