stewart's latest activity

  • S
    stewart replied to the thread High Roller frame size.
    Latest update: I have now test ridden the bike, or more correctly rolled the bike downhill, appropriately for the High Roller! Wasnt...
  • S
    stewart replied to the thread High Roller frame size.
    Thought its time for an update. im still progressing though with the heat I only work in the shed on cooler days. As vk3ckc's thread...
  • S
    stewart replied to the thread High Roller frame size.
    Thanks for the replies I will probably buy a cheap spring rear suspension unit an use that. I have already cut off the bottom bracket...
  • S
    stewart replied to the thread High Roller frame size.
    Questions about suspension. The AZ design calls for using front forks for the rear chain stays however since I have only one donor...
  • S
    stewart replied to the thread High Roller frame size.
    Thanks Popshot Turns out they are not cartridge but the bearings just sit inside the race which is press fitted into the head tube. The...
  • S
    stewart replied to the thread High Roller frame size.
    Another question I have cut the headset off the donor bike, a giant rincon and I want to remove the ballbearings to grease them/ I think...
  • S
    stewart replied to the thread High Roller frame size.
    Just imported Brads photo into sketchup and traced over it. Dimensions are 30" for the monotube as the plans show, this results in a...
  • S
    stewart replied to the thread High Roller frame size.
    Thanks everyone for your replies. I have uploaded 2 images from Sketchup onto Flickr so hopefully you can now see. I realised my...
  • S
    Just got the plans from AZ and have a question regarding the monotube length . The plans say it should be 30 inches (760mm) from the...
Top